Every line goes somewhere.
VANISH teaches the drawing system behind every street, room and object you have ever sketched: one horizon, a few points, and lines that all agree.
One, two, three.
The same box, the same paper. What changes is how many of its edge directions run away from you. Scroll to turn it, then tip it.
- 01
One point. The front face sits square to you. Only the depth edges recede, and they all meet at a single point on the horizon.
- 02
Two point. Turn the box. Both sets of horizontal edges recede now, to two points on the same horizon. Verticals stay vertical.
- 03
Three point. Look down. The verticals start to converge too, on a third point far below the horizon. This is the bird's eye.
The horizon is your eye.
The horizon line is not where the land ends. It is the height of your eyes. Raise the camera and the horizon climbs with you; everything below it shows its top.
At eye level the horizon passes through the head of every standing figure on flat ground.
Move the points.
Watch it all agree.
A street corner and a room are the same problem: horizontal edges of the world head for one of two points on the horizon. Drag any red point here or in the wordmark above and every drawing re-projects from the same pair.
- aPoints far apart give a long lens: calm, flat, architectural.
- bPoints close together give a wide lens: dramatic, then distorted.
Depth is
squeezed.
Tip a square away from you and it gets shorter, but not evenly. The far rows compress more than the near ones, because each step back covers less of your view. That squeeze is foreshortening.
- aThe side elevation shows why: sight lines to the card cross the picture plane closer together as it tips.
- bNever measure depth on the page with a ruler. Find it with diagonals (sheet 07).
A circle is a square
you rounded.
Draw the square in perspective first, find its centre with diagonals, then pass a smooth ellipse through the four midpoints. Plates near your eye level flatten into a line; plates far from it open up.
- aThe ellipse is never pointed at its ends. It is smooth all the way round.
- bThe true centre (where the diagonals cross) sits behind the ellipse's own middle.
The middle is
further back.
The centre of a rectangle in perspective is where its diagonals cross. A vertical through that point halves the wall exactly. Do it again in each half for quarters, again for eighths. Compare it with the middle you would measure with a ruler.
- aThe dashed tick marks the ruler's middle. It always lands too close to you.
- bDrag the red point: the diagonals stay true at every angle.
Six ways a drawing
stops agreeing.
The drafting table
Set your horizon and points, drag footprints on the ground and watch boxes extrude in true perspective. Export SVG, share by link.
Find the vanishing point
Drop the point where the lines meet, scored by distance. Then spot the one line that does not converge.